Troubleshooting Symptoms |
Issue |
Causes |
Solutions |
1080 |
1081 |
1082 |
| CARRIER BICYCLE STEERING |
| Wheels do not turn |
Steering Lock is engaged |
Unlock steering lock |
x |
x |
x |
| Leader pulls left or right |
Tire pressure may be uneven |
Inflate tires to 60-65psi |
|
|
|
|
ChildPod brake settings may be uneven |
Reset barrel adjustors at the hub |
x |
x |
x |
|
Tie Rod steering may be out of alignment |
Realign Tie Rod steering |
|
x |
x |
|
If you have a 1080 Series and cannot align steering… |
Update Tie Rod to 1081 Assembly |
x |
|
|
|
If you've set Tie Rod alignment and alignment is still off… |
Adjust stem to steerer tube alignment |
x |
x |
x |
| Does not turn evenly left to right |
Tire pressure may be uneven |
|
x |
x |
x |
|
Steering may be out of alignment |
Realign steering |
x |
x |
x |
|
Steering Limiter bolt may need to be adjusted |
Adjust Steering Limiter Bolt |
|
x |
x |
| |
Steering Limiter bolt is out out of spec (1080 Series only) |
Remove Steering Limiter Bolt |
x |
|
|
| Wheels stop too far from ChildPod frame |
Steering Limiter bolt may need to be adjusted |
Adjust Steering Limiter Bolt |
|
x |
x |
|
Steering Limiter bolt is out of spec (1080 Series only) |
Remove Steering Limiter Bolt (2009 model) |
x |
|
|
| Wheels stop too close to ChildPod frame |
Steering Limiter bolt may need to be adjusted |
Adjust Steering Limiter Bolt |
|
x |
x |
|
Steering Limiter bolt is out of spec (1080 Series only) |
Unresolvable |
x |
|
|
| There is excessive friction turning handlebar left to right |
Screws for water bottle cage may be turned in too far |
Add washers, unscrew screws slightly, or remove |
x |
x |
x |
|
Tie Rod End may be damaged (1080 Series only) |
Update Tie Rod to 1081 Assembly |
x |
|
|
|
May be friction between Pod drum brake back plate and ChildPod headset (1080 Series only) |
Insert 5/8" ID washer between hub and kingpin |
x |
|
|
| LEADERLINK CONNECTIVITY |
| Cycle fork dropouts does not fit onto bridle |
Paint may be too thick on fork dropouts |
File down excessive paint |
|
x |
|
| Cycle does not clamp onto ChildPod properly |
Fork dropouts may not be engaged with Steering interface Bridle properly |
Recouple Cycle to ChildPod |
x |
x |
x |
|
Brake cables may be running over Steering Interface Bridle |
Move brake cables below Steering Interface Bridle |
x |
x |
x |
| LeaderLink Braking does not couple properly |
Cable ends may not be seated into barrel adjustors |
Check that LeaderLink brake cables are seated properly into barrel adjustors |
x |
x |
x |
|
Cycle may not be fully seated on ChildPod |
Recouple Cycle to ChildPod |
x |
x |
x |
|
|
Check that dropouts have properly engaged the Steering Bridler |
x |
x |
x |
|
|
Check that clamp is snug and properly engaged |
x |
x |
x |
| Cycle does not slide onto Post smooth |
Too much friction between Post and Cycle |
Lubricrate LeaderLink post |
x |
x |
x |
| LeaderLink Braking sleeve |
Out of spec, may fall out of steerer tube |
Replace with proper sleeve |
|
x |
|
| RIDE QUALITY |
| Hard to pedal due to brake friction |
Parking brake may be on |
Release parking brake |
x |
x |
x |
|
ChildPod drum brakes may be set up incorrectly |
Reset barrel adjustors |
x |
x |
x |
|
Rear wheel may be incorrectly set up |
Adjust rear brakes |
x |
x |
x |
| CHILDPOD |
| Wheels do not slide onto hub |
Barrel adjustors are over adjusted |
Reset barrel adjustors |
x |
x |
x |
|
Cable ends are not seated into barrel adjustors properly |
Check cable ends |
x |
x |
x |
|
Parking brake is engaged |
Release parking brake |
x |
x |
x |
|
|
|
|
|
|
| Wheels do not come off the hub |
Barrel adjustors are over adjusted |
Reset barrel adjustor |
x |
x |
x |
|
Cable ends are not seated into barrel adjustors properly |
Check cable ends |
x |
x |
x |
|
Parking brake is engaged |
Release parking brake |
x |
x |
x |
| Caster Wheels won't go up |
Only one button is being pressed |
Press both buttons |
x |
x |
x |
| Caster Wheels won't go down |
No button is being pressed |
Press side button in |
x |
x |
x |
| Hard to control ChildPod in Stroller/Jogger Mode |
Steering Lock may not be engaged |
Engage Steering Lock |
x |
x |
x |
| CYCLE FRONT WHEEL |
| Cycle front brake is not set up |
Cycle front brake is not set up (1080 Series only) |
Set up front brake |
x |
|
|
| Cycle front wheel does not fit |
Straddle cable is still engaged |
Release straddle cable |
x |
x |
x |
| Straddle cable won't engage when front wheel is installed |
Cable ends may not be seated into barrel adjustors properly |
Check cable ends are properly seated into barrel adjustors |
x |
x |
x |
|
Barrel adjustors may be over-adjusted |
Reset barrel adjustors |
x |
x |
x |
|
Cable length may be too short |
Reset cable length |
x |
x |
x |
| SHIFTING |
| Mis-shifting |
Cable tension |
|
|
|
|
|
Derailleur adjustment |
|
|
|
|